Are you tired of that annoying drip, drip, drip coming from your bath tap? Not only is it wasteful, but it can also be expensive if left unchecked. But fear not, fixing a leaky bath tap is easier than you might think! Follow these 10 simple steps to get your tap back in working order in no time.
Step 1: Gather Your Tools
Before you begin, make sure you have all the necessary tools on hand. You’ll need an adjustable wrench, a screwdriver, plumber’s tape, and a replacement washer.
Step 2: Turn Off the Water Supply
Locate the shut-off valves under the sink and turn them off to stop the water flow to the tap. Then, open the tap to release any remaining water in the pipes.
Step 3: Remove the Tap Handle
Use the screwdriver to remove the handle of the tap. This will allow you access to the inner workings of the tap where the leak is likely coming from.
Step 4: Replace the Washer
Inside the tap, you will find a washer that is likely causing the leak. Use the adjustable wrench to remove the old washer and replace it with a new one of the same size.
Step 5: Reassemble the Tap
Once the new washer is in place, reassemble the tap handle and tighten any screws that may have come loose during the process.
Step 6: Turn the Water Supply Back On
Turn the shut-off valves back on and test the tap to ensure the leak is gone. If the tap still leaks, you may need to check for other issues such as a worn out valve.
Step 7: Check for Other Leaks
While you have the tap open, it’s a good idea to check for any other leaks or issues that may need attention. This will save you time and effort in the long run.
Step 8: Tighten Loose Fittings
If you notice any loose fittings or connections while inspecting the tap, use the adjustable wrench to tighten them up. This will prevent future leaks and ensure the tap works properly.
Step 9: Apply Plumber’s Tape
For extra protection against leaks, wrap plumber’s tape around the threads of any fittings before screwing them back in place. This will create a tight seal and prevent water from escaping.
Step 10: Test the Tap
Finally, turn the water supply back on and test the tap to ensure it is working properly. If the leak persists, you may need to seek professional help to diagnose and fix the issue.
Conclusion
Fixing a leaky bath tap doesn’t have to be a daunting task. By following these 10 simple steps, you can quickly and easily repair your tap and prevent further water wastage. Remember, regular maintenance is key to keeping your plumbing in good working order. If you found this guide helpful, please leave a comment below and share your experience with us!